MIL-DTL-44419A
finished item meets the government requirements, no trimmer attachments, other than a thread
undertrimmer, shall be permitted.
3.13 Figures. Figures 1-3 are furnished for information purposes only. If there are any
inconsistencies between the specification and the figures, the specification shall govern.
3.14 Finished measurements. The finished measurements for the glove shall be as specified in
Table X.
Table X. Dimensional Measurement of gloves (inches)
Overall length 1/
Width 2/
Size
X-Large Wide
12-3/8
5-1/2
X-Large
12
5-1/8
Large Wide
11-1/2
5-3/8
Large
11-1/8
4-3/4
Medium Wide
10-3/8
5-1/8
Medium
10-3/4
4-3/4
Small
10-1/4
4-1/2
Tolerance
+ 1/4
+ 1/4
1/ The glove length shall be measured from tip of middle finger to edge of stretch fabric cuff, at
the seam attaching the snow cuff. Do not include the snow cuff in the length measurement. The
glove shall be gently stretched lengthwise and then allowed to return to its natural state before
measuring.
2/ The glove width shall be gently stretched out and measured across the width on the hand/palm
portion, 1/2 inch down from the base of the little finger.
3.15 Workmanship. After completion of the final assembly, the glove shall be thoroughly
cleaned and all thread scraps, lint and foreign matter shall be removed. The gloves shall not
contain any fabric defects. The gloves shall be uniform in quality and shall be free from
irregularities or defects which could adversely affect performance, reliability or durability. The
gloves shall conform to the quality established by this specification.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.2).
b. Conformance inspection (see 4.3).
4.2 First article inspection. A first article inspection when required (see 3.1) shall be inspected
for the measurements listed in Table X, the defects in Table XI and tested for the characteristics in
Table XII.
4.3 Conformance inspection. Conformance inspection shall be performed on production lot
articles, and shall include the examinations in 4.4.2, 4.4.3 and end item testing specified 4.4.4.
14
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business