MIL-DTL-31008A
TABLE III. Manufacturing operations Continued.
No. Description of Operation
Stitch
Seam and
Stitches
Type
Stitching
Per Inch
Type
inch . Join with a single row of stitching
1/16 inch from the folded edge.
c. Raise stitch around the collar with a single row
301
SSe-2(b)
8-10
of stitching 1/4 inch from edge.
33. Make pull tab
a. Fabricate the pull tab for the slide fastener for
301
EFp-2
8-10
the front opening so that the finished pull tab will
be 1/2 inch wide by 3 inches long.
b. Pull the pull tab through the hole in the slider tab bartack
28 stitches per
pull so that the ends of the pull tab will be even.
bartack
bartack at the bottom, the center, and at the end
of the slider tab pull, across the 1/2 inch width.
34. Clean jacket
a. Trim all thread ends. Remove all loose thread ends.
b. Remove all spots, stains, and shade tickets without damage to the fabric.
3.6.1 Automatic equipment. Automatic machines may be used to perform any of the required
stitch patterns provided the requirements for the stitch pattern, stitches per inch, and sizes and
type of thread are met; and at least three typing, overlapping or back stitches are used to secure
the ends of the stitching.
3.7 Shade and size marking. The cut parts of the jacket shall be marked to ensure correct size
and uniform shade. Any method of marking may be used except:
a. Corrosive metal fastening devices
b. Sew-on type tickets
c. Adhesive type tickets which show discoloration or leave an adhesive mass that
adheres to the material upon removal of the tickets
d. Any marking medium which would tend to leave a permanent mark
3.8 Finished measurements. The finished measurements of the jacket shall conform to table IV.
20
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business