MIL-DTL-31008A
TABLE IV. Finished measurements (inches)
Size
Back Length 1/
1/2 Chest 2/
Sleeve inseam 3/
Small
21-3/4
23-1/2
20-1/4
Medium
22-1/4
25-1/2
20-1/2
Large
22-3/4
27-1/2
20-3/4
Extra large
23-1/4
29-1/2
21
Extra extra large
23-3/4
31-1/2
21-1/4
Tolerance
+ 3/8
± 1/2
+ 1/4
- 5/8
- 3/8
1/ Back length
- Measure at the center of the back, from the bottom of the undercollar
seam to the bottom above the knit.
2/ 1/2 Chest
- Measure at the base of the armhole, with the slide fastener closed, from
folded edge to folded edge.
3/ Sleeve inseam
- Measure along the underarm seam, from the armhole to the seam above
the knit.
3.9 Workmanship. Jackets shall be free of all loose thread, lint, and foreign matter. Jackets shall
uniform in quality and shall be free from irregularities. Occurrence of defects shall not exceed
the acceptance criteria established herein.
4. VERIFICATION
4.1 Classification of inspection. The inspection requirements specified herein are classified as
follows:
a. First article inspection (see 4.2)
b. Conformance inspection (see 4.3)
4.2 First article inspection. When required (see 3.1), the first article shall be inspected as
specified in 4.4.3.1 through 4.4.3.3 for compliance with design, construction, workmanship and
dimensional requirements. The presence of any defect shall be cause for rejection of the first
article.
4.3 Conformance inspection. Unless otherwise specified, sampling for inspection shall be
performed in accordance with ANSI/ASQ Z1.4. The acceptance criteria as specified in the
contract or purchase order shall be binding (see 6.4).
4.4 Component and material inspection. Components and materials shall be tested in
accordance with all the requirements of referenced specifications, drawings, and standards unless
21
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business