MIL-DTL-31008A
TABLE VI. Classification of defects.- Continued.
Defect
Major
Minor
center with center of back. Hanger stitched and bartacked through
outershell.
15. Fastener tape
Fastener tape (except wearer's namplate) misplaced, not serving
111
intended purpose. Hooks or loop flattened or missing from any fastener
tape area 25 percent or more. Fastener tape (hook and loop) for wearer's
nameplate missing. Fastener tape for wearer's nameplate not specified
type.
Hook fastener tape more than 1/4 inch out of alignment with loop fastener
213
tape. Fastener tape (except wearer's nameplate) not specified size. Hooks
or loops flattened or missing from any fastener tape area up to 25 percent.
Fastener tape for wearer's nameplate misplaced more than 1/2 inch. Stitching
omitted on one or more edges of loop tape for wearer's nameplate.
16. Heat sealed seams
Any seam tape not 1/8 inch overlap on each side of sewn seam. Any
112
seam tape not overlapped 3/4 inch minimum. Any area of the laminate
knit fabric bordering the seam tape that is melted exposing laminate
film.
Any seam tape not located as specified. Any required stitching not
214
covered by seam tape. Any needle punctures that have not been repaired
using heat sealing tape.
17. Repairs
Any heat sealing repairs extending beyond 25 inches in length. More
than five repairs on any one item.
18. Seam tape adhesion
Visible scorching (heat degradation of the fabric on the laminate) in
215
excess of 3/16 inch in width or 1/2 inch in length at any location along
a tape seam.
Seam tape lifting off fabric within 3/4 inch of seam.
113
19. Fusible material
Omitted from undercollar, topcollarstand, pocket flaps, protective
114
Fly, or epaulet. Partial or complete delamination on any fused
Component. Bubbling on any fused component. Any strike through
Or bleed through. Any resin transfer on any fused component. Any
26
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business