MIL-DTL-43549D
TABLE III. Finished measurements
6-1/2
6-3/4
7
7-1/4
7-1/2
7-3/4
Toler-
Size
7-7/8
8
ance
Inside 1/
Circumference
21
21-3/4
22-1/2
23-1/4
24
24-3/4
+/- 1/2
25-1/8
25-1/2
Gusset width
2
2
2
2
2
2
+/- 1/4
2
2
2/
1/ Measure the inside circumference at center of sweatband without stretching.
2/ Measure across the top of gusset at top crown joining seam,
3.9.2 Workmanship. The end item shall conform to the quality of product established by this
specification and the occurrence of defects shall not exceed the applicable acceptable quality levels.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified
as follows:
a. First article inspection (see 4.3).
b. Acceptance criteria (see 4.4).
4.2 First article inspection. When a first article is required (see 3.1 and 6.2), it will be
examined for the defects specified in 4.4.3 and 4.4.4.
4.3 Acceptance criteria. Acceptance criteria will be performed as specified in the contract
or purchase order.
4.3. Component and material inspection. In accordance with 4.1, components and materials
will be inspected in accordance with all the requirements of referenced documents unless otherwise
excluded, amended, modified, or qualified in this specification or applicable
purchase document.
4.4 End item visual examination. The end items will be examined for the defects listed in
Table IV. The lot size will be expressed in units of caps. The sample unit will be one cap.
110p16" style="font-size:12px">16
Downloaded: 2014-09-28T11:49Z
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business