MIL-DTL-31008A
of compliance shall be submitted stating that the batting insulation conforms to the requirements
above (see 4.1.).
3.2.9 Seam sealing tape. The tape for covering and sealing all designated seams and stitching
shall be cut in 1 inch wide (± 1/16) inch strips from material that is compatible with the back
side of the cloth specified in MIL-DTL-31011.
3.2.10 Fastener tape. The hook and loop fastener tape shall be Black 3230 conforming to type I
or type II, class I of A-A-55126, as follows:
Nameplate
2 by 4
Pocket flap
1 by 5
Epaulets
1 by 1
Note: The loop fastener for the nameplate shall be 2 inches by 4 inches. The hook fastener tape
for the nameplate shall be 2 inches by 4 inches. The hook tape for the nameplate may be one
piece or two pieces. If it is two pieces, only one seam is allowed. Overlap selvage edge of hook
tape 1/8 (± 1/16) inch and stitch through both plies using 304 stitch type, LSa-1 seam with 8-10
stitches per inch.
3.2.11 Twill cloth. The material for the inside hanging pocket shall conform to class 1 or 2 of A-
A-52106 and the color shall be black.
3.2.12 Cord. The cord beading used in the edges of the front opening separation slide fastener
cover shall be natural, size no. 18 of A-A-2917.
3.2.13 Labels. Each jacket shall have a combination size, identification label, and instruction
label. The colorfastness to laundering requirements of MIL-DTL-32075 shall apply.
3.2.13.1 Combination size and identification label. The combination size and identification
label shall conform to type VI, class 1 and 2 of MIL-DTL-32075:
Size: 1/
Jacket, Security Forces, Cold Weather
Contract No. SP0100-XX-X-XXXX 1/
NSN
Contractor's Name: 1/
1/ The contractor shall insert the applicable information.
3.2.13.2 Instruction label. The instruction label shall conform to type VI, class 3 of MIL-DTL-
32075 and shall contain the following information:
JACKET, SECURITY FORCES, COLD WEATHER
Wash in low temperature (do not exceed 100 degrees F)
Use a mild non-phosphate detergent
Tumble dry, low heat cycle (de not exceed 100 degrees F)
NOTE: Do not starch, bleach, dry clean, or steam press
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business