MIL-DTL-83776B(USAF)
TABEL IV. End item visual defects (con't)
Defects
Classification
Major
Minor
A B
Sockets (con't)
2. Alignment
- one or more sockets out of alignment with stud seriously
X
- affecting appearance.
b. Studs
One or more omitted, defective or improperly clinched.
X
4.6 Size measurements. Any measurement deviating from the nominal dimension and tolerance in table
of measurements will be scored as a size measurement defect.
4.7 Packaging examination. The fully packaged end items will be examined for the defects listed
below. The lot size will be expressed in units of shipping containers. The sample unit will be one
shipping container fully packaged.
Examine
Defect
Marking
Omitted, incorrect, illegible, of improper size, location, sequence of
(exterior and
method of application.
interior)
Materials
Any component missing.
Any component damaged, affecting serviceability.
Workmanship Inadequate application of components, such as 1ncomplete
closure of case liners, container flaps, loose strapping,
inadequate stapling, bulging or distortion of containers.
Content
Number of bundles per container is more or less than required.
Number of helmets per bundle is more or less than required. it
Size shown on one or more helmets not as specified on outer container. 1/
1/ For this defect, two bundles from each container in the sample will be examined.
5. PACKAGING.
16
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business