MIL-DTL-44048H
Size
XXX-
XX-
X-Short
Short
Regular
Long
X-
XX-
Short
Short
Long
Long
Collar - Type I, VI &
2-1/2
2-1/2
2-1/2
2-1/2
2-1/2
2-1/2
2-1/2
2-1/2
VIII , + 1/8 in
Collar - Type VII,
4
4
4
4
4
4
4
4
+ 1/8 in.
Method of measuring. The coat shall be placed flat upon a table and measured as follows:
Half Chest-With coat buttoned, measure from folded edge to folded edge across coat chest in line
with pit of armhole.
Back Length-Along center back measure from undercollar seam to bottom edge of coat.
Sleeve Length-Fold sleeve along underarm seam, measure along folded edge of the top sleeve from
shoulder seam to the bottom of the sleeve cuff.
Collar-Measure from collar seam along edge of collar to collar point.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the
contract or purchase order (see 6.2). When actual packaging of material is to be performed by DoD
personnel, these personnel need to contact the responsible packaging activity to ascertain requisite
packaging requirements. Packaging requirements are maintained by the Inventory Control Point's
packaging activity within the Military Department's System Command. Packaging data retrieval is
available from the managing Military Department's or Defense Agency's automated packaging files, CD-
ROM products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Intended use. The coats are for wear by military personnel of the Department of Defense as an
outer garment in garrison, combat, and operations other than war: Type I and IX in temperate foliated
areas, type VI and X in hot humid foliated areas, type VII and XI in desert areas, and type VIII and
XII where required.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number and date of this document.
b. Types, classes and sizes required (see 1.2).
c. Issue of DODISS to be cited in the solicitation and, if required, the specific issue of
individual documents referenced (see 2.2.1 and 2.3).
d. When first article sample is required (see 3.1, 4.2 and 6.3).
e. Packaging requirements (see 5.1).
16
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business