MIL-DTL-44048H
4.4.8.9 Report. The mg permethrin/cm2 shall be reported as the mean of the values obtained for the
sample and reported to the nearest 0.001 mg. The individual values of each specimen used to calculate
the mean shall be reported to the nearest 0.001 mg.
NOTE: The conditions described in this method are optimum for the gas chromatograph employed.
These conditions may vary depending on the gas chromatograph used. The carrier gas flow rate shall
be adjusted so that the elution of the first permethrin isomer is greater than 5 minutes.
4.4.9 End item visual examination. The coat shall be examined for the defects listed below.
EXAMINATION
DEFECT
Material and
Component part omitted, distorted, full, tight, or twisted; any part of coat
workmanship
caught in any unrelated stitching, the edge of any component part required
to be forced out having folds of more than 1/8 inch
Hole, cut, tear, smash, burn, drill hole, run, thin place, dye streak, color
not as specified, misweave, knot or slub affecting appearance or
serviceability
Seam: puckered, distorted, pleated, wavy, twisted, irregular or open,
loose or tight stitch tension, broken or missing thread or stitch, needle
chew, visible mend, edge or raised stitching sewn too close to edge,
resulting in damage to cloth, seam allowance not as specified, raw edge
affecting appearance or serviceability
Length of fronts uneven by more than 1/4 inch at top or uneven by more
than 1/4 inch at bottom when buttoned, front buttons and buttonholes out
of alignment, causing bulge or twist on fronts when buttoned
Permanent fold, pleat, or crease affecting appearance or serviceability
Front pockets and flaps: not uniform in size or shape, out of alignment by
more than 3/8 inch, front edge not parallel to front edge of coat by 3/8
inch or more, pleated, twisted, curled or puckered, not stitched as
specified, flap not completely covering pocket opening, bellows exposed
beyond edge of pockets more than 1/8 inch, tab shows beyond the flap,
tab is caught in edge stitching at bottom of flap, buttons and buttonholes
out of alignment, causing bulge or twist on pockets when buttoned
Collar points uneven in length by 1/4 inch or more, collar curls, puckers,
pleats, or twists
Buttonholes and eyelets omitted, added, not clean cut or securely caught in
fabric, not specified type
Buttons missing, broken, defective, not attached as specified, or insecurely
sewn
Bartacks or backtacks missing, insecure, misplaced, not specified size,
stitches loose or broken, or not serving intended purpose
14
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business