MIL-DTL-14610H
TABLE III. Finished measurements (continued)
Size
X-Small Small
Medium Large
X-Large
Sleeve inseams 3/
Short
-
22
22
22
22
Regular
23
23
23
23
23
Long
-
24
24
24
24
Leg inseams 4/
30
30
30
30
-
Short
32
32
32
32
32
Regular
34
34
34
34
-
Long
Overall Length 5/
Short
-
62-1/2
63-1/2
64-1/2
65-1/2
Regular
64-1/2
65-1/2
66-1/2
67-1/2
68-1/2
Long
-
68-1/2
69-1/2
70-1/2
71-1/2
NOTE: Tolerances shall be + 1/2 inch.
1/ Measure across the front at the base of armhole from folded edge to folded edge.
2/ Measure across the waist from folded edge to folded edge.
3/ Measure from the base of armhole along inseam to bottom of sleeve hem.
4/ Measure from crotch seam along inseam to bottom of leg hem.
5/ Fold coverall in half (back to back) and measure from base of neck (close to hanger loop)
straight down to the bottom of the leg.
3.10 Workmanship. The finished coveralls shall conform to the quality of product established by
this document.
3.11 First Article. When specified (see 6.2), a sample shall be subjected to first article inspection
in accordance with 4.2.
4. VERIFICATION
4.1 Classification of inspection. The inspection requirements specified herein are classified as
follows:
1. First article inspection (see 4.2)
2. Conformance inspection (see 4.3)
4.2 First article inspection. The first article when applicable, submitted in accordance with 3.11,
shall be inspected for compliance with design, configuration, workmanship and dimensional
requirements. The presence of any defect (see 4.3.5) or failure to pass any test shall be cause for
rejection of the first article.
4.3 Conformance inspection. Sampling for visual and dimensional inspection shall be performed
in accordance with ANSI/ASQC Z1.4, except where otherwise indicated.
4.3.1 Component and Material Inspection. In accordance with 4.1, components and materials
shall be tested in accordance with all requirements of referenced documents unless otherwise
excluded, amended, modified, qualified in this document or applicable procurement documents.
4.3.2 Test methods. The finished basic material shall be tested for the characteristics listed in
Table IV.
6
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business