MIL-DTL-27546E
of the outershell material or shall be black. The placement of the snaps shall be as indicated on
the pattern.
3.4.5.1 Jacket Liner Front opening. The top snap shall be placed 1/2 inch down from the collar
and the last snap 1 inch above the finished bottom hem with the remaining snaps evenly spaced in
between according to the marks on the pattern.
3.4.5.2 Jacket liner and trouser liner. Two female portion snaps shall be located on each inseam
to be used to attach the liners together. The first snap shall be 1-1/2 inches upward from the
finished bottom hem. The second shall be 1-1/2 inches upward from the first snap fastener and in
vertical alignment. One corresponding male portion of the snap shall be located on each trouser
outseam approximately 3 inches (+ 1/4 inch) from the top edge of the trouser.
3.4.6 Elastic webbing (trouser liner). The 1-3/4 inch wide elastic webbing shall have a thickness
of .048 inches minimum and a maximum weight of .95 oz. per linear yard when tested in
accordance with paragraph 4.4.
3.5 Labels. Each liner shall have a combination identification/size label, and a laundering label
stitched on all sides approximately 1/2 to 1 inch below the collar seam on the jacket liner and
stitched on all sides below the lower row of waistband stitching on the inside back above the right
patch hip pocket on the trouser liner. The inscription shall have a minimum font size of 10. The
inscription legibility, label, and label attachment shall last the expected life of the coveralls.
3.5.1 Identification/size label. The identification/size label shall contain the following information:
Liner, flyer's CWU 9/P (jacket or trousers)
Contract number
Textile Fiber Products Act Information
Contractor's name
Size
Stock number
3.5.2 Laundering instruction label. The laundering instruction label shall contain the following
information:
1. Machine washing. Use Permanent Press Cycle. Wash in warm water with mild detergent.
2. Hand washing. Wash in warm water using mild detergent. DO NOT WRING OR
TWIST. Rinse in clean warm water.
3. DO NOT USE CHLORINE BLEACH OR STARCH.
4. Dry at low heat (do not exceed 1300 F). After drying, tumble at room temperature for 10
minutes. Remove immediately from dryer. To drip dry, remove from water and place on
rust-proof hanger.
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business