A-A-55063A
legible and readable by a scanner. The barcode element will be a 13 digit national stock number
(NSN) along with respective Universal Product Code (UPC) bar code. The bar code type shall
be a medium to high code density and shall be located so that it is completely visible on the item
when it is folded and/or packaged as specified, and so that it causes no damage to the item.
3.3 Patterns. Commercial patterns shall be used. They shall conform to the design
requirements of 3.1.
3.4 Construction. Construction of garment shall be according to good commercial practices.
and conform to the design in 3.1 and the dimensions specified in 3.5.
3.5 Dimensions The dimensions shall be as specified in Table IV and Figure 1.
TABLE IV. Dimensions (inches)
Location or designated component
Dimension
Tolerance
A) Bottom Width, edge to edge
34-5/8
± 3/4
B) Side Length, waist to bottom edge
36-7/8
± 3/4
C) Length, neck edge to bottom edge
48
± 3/4
D) Bib Width, edge to edge
11-3/8
± 1/4
E) Sweep Width, neck edge to waist edge
11-5/8
± 1/4
1 inch from all
F) Grommet placement
± 1/8
designated corners
3.6 Toxicity. The finished apron shall not present a health hazard and shall show
compatibility with prolonged, direct skin contact when tested as specified in 5.4. Chemicals
recognized by the Environmental Protection Agency (EPA) as human carcinogens shall not be
used.
3.7 Workmanship. The finished apron shall conform to the quality of product established by
this document and shall be thoroughly cleaned and all loose thread and foreign matter removed.
4. REGULATORY REQUIREMENTS. Unless otherwise specified (see 3.2.1.1.1). The
offeror/contractor is encouraged to use recovered materials to the maximum extent practicable,
in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
5. PRODUCT CONFORMANCE PROVISIONS.
5.1 Product conformance. The products provided shall meet the salient characteristics of this
Commercial Item Description, conform to the producer's own drawings, specifications,
standards, and quality assurance practices, and be a similar product that is offered for sale in the
commercial marketplace. The Government reserves the right to require proof of such
conformance.
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business