A-A-50379
3.2 Examination of the end item. The mitten shells shall be inspected in accordance with MIL-STD-105. The defects found during the examination of the end item shall be as classified below. The applicable inspection levels and acceptable quality levels (AOL’S) shall be as indicated in 3.3. The lot size shall be expressed in units of are mitten shell each. The sample unit shall be one mitten shell and selection shall be by pairs. Defects for pairing shall be classified as a single defect.
|
Defects |
Classification |
|
|
Major |
Minor |
|
|
I. MATERIAL DEFECTS AND DAMAGES |
||
|
a. Hole, cut, tear, needle chew, abraded surface, weak or thin spot, hard scars, brittle or bony area, or deep grain damage |
X |
|
|
b. Color not as specified |
|
X |
|
II. CLEANESS |
||
|
a. Any spot or stain (outside) |
|
X |
|
b. Thread ends not removed |
|
X |
|
III. DESIGN AND ASSEMBLY |
||
|
a. Improper function of buckle |
X |
|
|
b. Not cut or fabricated in accordance with the product demonstration model |
X |
|
|
IV. PAIRING |
||
|
a. Mispaired, i.e., two lefts or two rights |
X |
|
|
V. LABEL |
|
|
|
a. Label missing, incorrect, or illegible |
|
X |
|
VI. GENERAL |
||
|
a. Any defect not otherwise classified herein but at variance with the product demonstration model |
|
X |
|
VII. DIMENSIONS |
|
|
|
a. Not within tolerance range |
X |
|
3.3 Inspection level and AQL’s. The inspection level and acceptable quality levels (AQL’s) expressed in defects per 100 units for visual and dimensional examinations shall be as follows:
|
|
AQL’S |
Inspection level |
|
For visual examination |
||
|
Major |
2.5 |
II |
|
Total (Major and Minor) |
6.5 |
II |
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business