[INCH-POUND]
A-A-50363
7 January 1991
SUPERSEDING
A-A-50363
12 February 1985
COMMERCIAL ITEM DESCRIPTION
JUMPER, RADIOACTIVE CONTAMINANTS PROTECTIVE (VINYL)
This Commercial Item Description is authorized for use by all Departments and Agencies of the Department of Defense.
Description – The jumper shall be a pullover body style with elastic attached at the neck, waist and wrist openings of the full length sleeves. The elastic shall be attached with a seam or may be encased in heat sealed tunnels. The joining seams shall be heat sealed (non-embossed) to finish on the inside of the garment.
Material – The material for the jumper shall be made of a yellow plastic film, flexible, vinylchloride, 0.0080 (± 0.0008) inch thick, conforming to type I, class 2 of L-P-375, except that the requirements for extraction in soapy water, volatility, resistance to weathering, cold crack, and lacquer lifting shall not apply. No pinhole are allowed.
Sizes and measurements – The jumper shall be one type in one size. All measurements and tolerances are expressed in inches. The finished jumper shall have the following measurements when measured flat:
|
Chest (across front at armpit) |
- 35 |
|
Waist (fully expanded across bottom - minimum) |
- 25 |
|
Sleeve Inseam Width (6 inches above elastic) |
- 22-1/2 - 9 |
|
Length (shoulder to bottom of jumper) |
- 35-1/2 |
|
Tolerances |
- ±1 |
|
Beneficial comments (recommendations, additions, deletions) and any data pertinent data which may be of use in improving this document should be addressed to: Officer in Charge, Navy Clothing and Textile Research Facility, Post Office Box, 59 Natick, MA 01760-0001 by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) Appearing at the end of this document or by letter. |
DISTRIBUTION STATEMENT A. Approved for public release, distribution is unlimited.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business