A-A-50068
May 27, 1987
COMMERCIAL ITEM DESCRIPTION
APRON, LABORATORY, PLASTIC
The General Services Administration has authorized the use of this commercial item description in preference to Military Specification MIL-A-41801.
1. CLASSIFICATION
1.1 Classification. This commercial item description covers aprons of the following types:
Type I - Plain
Type II - With pocket and trough
2. SALIENT CHAMCTERISTICS
2.1 Design and construction, type I. The apron shall have a bib and tie tapes, approximately 22 inches long by one inch wide. The apron shall be approximately 45 inches long by 29 inches wide. The straight area shall be approximately 35 inches long and shall be so cut that the neckline is approximately 10 inches wide. The apron and tie tapes shall be constructed of clear, colorless, polyvinyl chloride plastic film with a minimum 0.008 inch thickness. The outside perimeter of the apron shall have a 1/2 + 1/16 inch wide heat sealed hem. The tie tapes shall be heat sealed to the apron at the beginning of the bib and shall be reinforced to the apron with an extra strip of vinyl. The neck shall be heat sealed to the apron at each end of the 10-inch neckline width.
2.2 Design and construction, type II. The type II apron shall have all the characteristics of the type I apron and shall have an additional pocket and trough. The pocket shall be located in the center of the bib area and the trough shall be located at the bottom hem. The top of the pocket shall be approximately 3 inches down from the apron lap, the trough shall be 2-3/4 + 1/4 inches high by the width of the apron. The pocket and trough shall be constructed of the same material and thickness as the type I apron. The edges of the pocket and trough shall be heat sealed. 1/8 inch minimum width. The pocket shall have a snap fastener. The male and female snap fastener halves shall be reinforced with at least one extra layer of vinyl film where they are attached to the apron and pocket. The male and females halves shall be centered and shall be approximately l-inch distance from the top of pocket.
3. QUALITY ASSURANCE
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business