MIL-DTL-43511D
ASTM D 1044
Standard Test Method for Resistance of Transparent
Plastics to Surface Abrasion
ASTM D 3935
Standard Specification for Polycarbonate (PC) Unfilled and
Reinforced Material
ASTM D 3359
Standard Test Method for Measuring Adhesion by Tape
Test
(Copies of these documents are available from
www.astm.org<BLOCKED::https://www.astm.org/> or the ASTM International, 100 Barr Harbor
Drive, West Conshohocken, PA 19428-2959.)
AMERICAN SOCIETY FOR QUALITY
ANSI/ASQ Z1.4
Sampling Procedures and Tables For Inspection by
Attributes (DoD adopted)
(Copies of this document are available from www.asq.org<BLOCKED::https://www.asq.org/> or
the American Society for Quality, 600North Plankinton Ave., Milwaukee, WI 53203-2914 or
www.ansi.org<BLOCKED::https://www.ansi.org/> or the American National Standards Institute,
25 West 43rd St., 4th Floor, New York, NY 10036.)
INTERNATIONAL COMMISSION ON ILLUMINATION (CIE)
CIE 1924 Standard
(Copies of these documents are available from www.cie-usnc.org<BLOCKED::https://www.cie-
usnc.org> or the CIE/USA Publications Office, c/o TLA-Lighting Consultants, Inc., 7 Pond St.,
Salem, MA 01970.)
2.4 Order of precedence. In the event of a conflict between the text of this document and the
references cited herein (except for related specification sheets), the text of this document takes
precedence. Nothing in this document however, supersedes applicable laws and regulations
unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection
in accordance with 4.2.
3.2 Design and dimensions. The design and dimensions of the visor shall be as specified in the
end item specification, drawing or contract as applicable.
3.3 Materials and components. Unless otherwise specified in the end item specification,
drawing, or contract as applicable, the visor shall be fabricated from bisphenol type
polycarbonate plastic molding material conforming to ASTM D 3935. All other material and
components used in the construction of the visor shall be as specified in the end item
specification, drawing, or contract, as applicable.
3.3.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided
that the material meets or exceeds the operational and maintenance requirements, and promotes
economically advantageous life cycle costs.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business