A-A-50359B
Defects. The shoes shall be examined for the defects listed below. The lot size shall be expressed in units of one finished shoe and selection shall be by pairs. During the manufacturing process, the manufacturer shall remove parts with defective materials and workmanship damages and replace with non-defective components.
a. Not properly mated, i.e., not left and right of same size.
b. Leather damages (scratches, slaughter cuts, cuts on grain surface, pronounced veins, etc.)
c. Torn or excessively full linings.
d. Materials not as specified.
e. Construction not in accordance with standard industry practice.
f. Broken upper stitches not repaired.
g. Separation of any bottom component.
h. Protruding tack, staple or nail in heel area.
i. Label incomplete, not eligible.
j. Upper leather defects (scars, veins, fat, wrinkles, pipey, stretchy, excessive break, etc.)
k. Rolled or curled counter.
l. Any shoes not packaged in accordance with the contract or purchase.
1/ When this defect is found, the defect shall be scored and the item shall be rejected, replaced or excluded from the lot.
Preservation, packing, and marking. The preservation, packing, and marking shall be as specified in the contract or purchase order.
Special marking. Instruction sheet or tag shall be furnished with each pair of shoes to inform the user of the following requirements:
a. Wear shoes with cotton socks for best conductivity.
b. Test shoes for required conductivity when issued.
c. Test shoes at least once every month thereafter to ensure electrical resistance does not exceed the allowable limit.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business