A-A-50194B
TABLE III. Finished measurements
Finished measurements Tolerance (inches)
(A) Length |
19 inches |
± 1 |
(B) Width (C) Face opening |
8-1/4 inches 7-1/4 inches |
± 1/2 ± 1/4 |
(A) Place hood on a flat surface and align bottom edges of front and back, close top and bottom edges of the face opening. With hood in this position, measure length in a straight line from folded edge at center of crown to bottom of hood. (See figures 2)
(B) With hood positioned as indicated above, measure across the hood in a straight line from folded edge to folded edge at face opening. (See figure 2).
(C) Place hood on a flat surface and fold in half lengthwise, pull hood so the curvature along side edges of face opening is straight. Measure along the edge of face opening from fold at center front to fold at center neck. (See figure 2).
3.5 Figures. Figures are furnished for information purposes only. When inconsistencies exist between the written specification and the figures, the written specification shall control.
3.6 End item performance testing. The finished hood shall neither shrink nor elongate more than
7.0 percent maximum in either the length or width direction when test in accordance with
AATCC 135, Table I, (2), (II), (D).
4. REGULATORY REQUIREMENTS.
4.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance requirements, and promotes economically advantageous life cycle costs.
5. PRODUCT CONFORMANCE.
5.1 Product conformance. The products provided shall meet the salient characteristics of this commercial item description, and shall conform to the producer's own drawings, specifications, standards and quality assurance practices. The Government reserves the right to require proof of such conformance.
5.2 Acceptance criteria. Acceptance criteria shall be as specified in the contract or purchase order.
5.3 End item visual and dimensional examinations. Each hood selected for examination shall be visually and dimensionally examined. Lot inspections shall be in accordance with ANSI Z1.4.
5.3.1 Defects. The hood shall be examined for the major defects listed below.
Source: https://assist.dla.mil -- 4Downloaded: Check the source to verify that this is the current version before use.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business