A-A-50194B
3.2.3 Interlining. The wind barrier interlining shall be a tightly woven nylon material conforming to the requirements listed in Table II below.
TABLE II. Interlining physical requirements
Characteristics |
Requirements |
Test Method |
Air Permeability (maximum) Colorfastness to: (minimum) Perspiration 1/ |
15 Ft3 /min/ft2 Class 4 or good |
ASTM D737 AATCC 15 |
Laundering 2/ |
Class 4 or good |
AATCC 61, Test 1A |
1/ The test for colorfasteness for acid and alkaline solution shall apply.
2/ The specimen shall be dried after each of the three laundering cycles. The soap solution shall
contain 0.5 % by weight, P-D-245, detergent, laundry, and hand dishwashing (granular) Type II
in water hardness not over 50 parts per million. The weight of the specimen shall be 4.0 ± 0.5 grams for yarn and fabrics and the rotating time shall be 30 minutes with ten stainless steel balls in each cylinder.
3.2.4 Seams and stitching. All seams and stitches shall be in accordance with ASTM D6193. Seam allowances shall be maintained with seams sewn so that no raw edges, runoffs, pleats, puckers or open seams occur. Thread tension shall be maintained so that no tight or loose stitching will result. Overedge stitching shall be 3/16 to 1/4 inch wide. Type 401or 504 stitching shall be used to seam the upper portion of the hood together. Both ends of the stitching produced with the 401 stitching shall have a 1/2 inch chain extending beyond each end. Type 504 or 505 stitching shall be used on face opening and bottom edges of hood.
3.3 Labels. Each hood shall have an identification and a care label attached. The labels may be combined. The labels shall be in accordance with MIL-DTL-32075, Type VI, except the font size shall be 10 points. Class 4 of the MIL-DTL-32075 shall be used for the identification label, except the size shall be omitted and class 3 shall be used for the care label. When the labels are combined the item description shall be omitted.
3.3.1 Care Label. The care label shall include the following information:
WASH BY HAND, COOL WATER SQUEEZE, DON'T WRING
LAY FLAT, SHAPE, AIR DRY
DO NOT MACHINE WASH, DRY, OR BLEACH
3.3.2 Bar-code label/tag. Each item shall be individually bar-coded with a Type VII, Class 17, Label/Tag of MIL-DTL-32075. The Label/Tag shall be located so that it is completely visible on the item when it is folded and/or packaged as specified and shall cause no damage to the item.
3.4 Measurements. The hood shall meet the finished measurements specified under Table III. See figure 2.
Source: https://assist.dla.mil -- 3Downloaded: Check the source to verify that this is the current version before use.
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business